As a mold maker, I’ve never understood why some bosses are so reluctant to allow the mold maker five minutes to familiarize himself with the molded part he is about to build a mold for. This would save a lot of visualizing and guessing. It is always much easier to begin with the end in mind.
This seems so obvious, but it is rare that the moldmaker actually gets to see what it is he is making! It is almost as if somebody thinks it is cheating or something! Why not go ahead and give the poor guy an advantage? It only means higher productivity!
You can get the full story on the Ten Top Tips For Injection Mold Making from our website, check it out!
Recent Comments